You plug headphones into a phone, turn it up, and still cannot get enough level. To work out whether voltage, current or gain is the constraint, start with impedance and sensitivity, including their units. The ohm figure alone tells you little about the pairing.

Why 32 ohms does not mean “easy”

Low impedance needs less voltage for the same power, but more current. High impedance does the opposite. If the source has a current limit — typical of many headphone outputs on small devices — a 16-ohm headphone can strain it more than a 300-ohm one.

To choose a source, read impedance alongside sensitivity and the output’s voltage and current limits.

The unit problem

Sensitivity appears in two forms, and they are not equivalent:

  • dB SPL per milliwatt — referenced to delivered power;
  • dB SPL per volt — referenced to applied voltage.

Comparing dB/mW directly with dB/V can introduce a large numerical mismatch. This is not a comparison of actual listening levels and does not establish a doubling of perceived loudness.

The conversion uses impedance at the measurement point, approximated here as a resistance R in ohms, and a reference of 1 V RMS: S(dB/V) = S(dB/mW) + 10·log₁₀(1000/R).

ImpedanceCorrection (dB/V − dB/mW)
16 Ω+18.0 dB
32 Ω+14.9 dB
64 Ω+11.9 dB
300 Ω+5.2 dB
600 Ω+2.2 dB

Example: a 32 Ω headphone rated 100 dB/mW equals roughly 115 dB/V. If you compare it with another rated at 105 dB/V without converting the units, you would incorrectly conclude that the second is more sensitive.

What you actually need to know

Shure points out that specifications must be read in relation to the application and with complete units ( Shure ). In practice:

  1. Maximum RMS source voltage into the headphone load, before clipping or current limiting.
  2. Headphone sensitivity in dB/V, converted if needed.
  3. Headroom: how many dB remain before clipping, accounting for quietly recorded tracks.
  4. Source output impedance, which with low-impedance headphones can alter frequency response.

Treat the calculation as an estimate. Sensitivity specifications have tolerances and recording levels vary, so allow for both when assessing headroom.

A comparison sheet

ItemWhy it matters
Exact model and revisiontwo revisions can use different drivers
Nominal impedancebasis for conversion
Sensitivity with referencewithout units the number is useless
Source usedvoltage and output impedance
Measurement conditionsmethod declared by the manufacturer

If a datum is missing, flag it. Do not fill it with an assumption: that is how wrong recommendations are born.

To understand how the transducer produces movement, see planar and dynamic ; for the signal path upstream, lossless audio .

The table’s corrections use 10·log₁₀(1000/R), rounded; they are calculations, not measurements of headphones or amplifiers. Use them to compare specifications in matching units. Electrical compatibility is a separate issue from choosing a safe listening level.

Sources

Report a correction ↗